For issues dealing with the Brooktrout configuration, licensing and devices
Answer PROBLEM When attempting to re-install the Brookrout TR1034 drivers, you see the following error message: Driver version already installed This may occur even though the TR1034 Drivers have been...
Overview After a FaxMaker upgrade, including Brooktrout drivers, the following error is encountered: Incompatible driver version detected Solution The upgrade has replaced Dialogic Brooktrout driver...
Overview You may experience faxes failing in general or faxes to a specific number are failing when sent. This article provides information on a possible solution to this issue when using a Brooktrou...
Overview The Brooktrout SR140 is a Fax over IP (FoIP) device that works with FaxMaker to send faxes in a network environment. Support for multiple gateways for outbound faxing has not been possible u...
Overview A fax was sent with more than 30 fax pages but the receiver receives only 30 fax pages. The log files show that all fax pages were sent without any errors. Environment GFI FaxMaker Dialogic B...
Overview When using a Brooktrout device and the Brooktrout Boston Host Service will not start, especially after an upgrade, you start the services and the lines do not initialize and give the error In...
Overview The purpose of this article is to provide information about configuring another gateway(s) for use with additional SIP providers in the Brooktrout Configuration Tool for sending faxes from ...
Overview When adding a new Brooktrout device to your system, you may experience uninitialized lines when attempting to add the lines in FaxMaker or you are trying to add lines to a digital card. This...
Overview When working with the Brooktrout SR140, it must be configured with the PBX or call manager being used. This article provides information about configuring the systems DIalogic has tested with...
Overview The purpose of this article is to provide a resolution for the issue of FaxMaker not working after a reboot. There will usually be no lines present in the FaxMaker monitor when this happens ...
